Signal Too Low. Intermittent Fault

Signal too low. Intermittent fault

Checking wiring and connectors
Check the cables between fuel level sensor connector terminal #5 and breakout box terminal #A02 (#A2). Check for an intermittent short-circuit to ground. Check for an intermittent open-circuit.
Check the ground lead between breakout box terminal #A10 (#A10) and fuel level sensor connector terminal #6. Check for an intermittent open-circuit.

Other information:
- For further information about signals and other values, see Signal specification Pinout Values and Diagnostic Parameters
- To connect the breakout box, see Connecting the breakout box Connecting the Breakout Box
- To access the rear electronic module (REM), see Relay/fuse box cargo compartment/Rear electronic module (REM), replacing Integrated Relay/Fusebox Cargo Compartment/Rear Electronic Module (REM), Replacing
- To access the fuel level sensor (left-hand side), see Level sensor fuel tank, replacing Service and Repair
- Checking wiring and terminals Checking Wiring And Terminals.










Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

FAULT FOUND - Fault Found

Attempt New Test - Checking wiring and connectors

-------------------------------------------------