Signal Too Low

Signal too low

Checking the status
Check if the fault is permanent or intermittent by activating the relay a few times.
A clicking sound is audible from relay 2/140 on the rear electronic module (REM) during activation.
If the relay does not activate, the fault is permanent.
If the relay activates, the fault existed previously but is not active at the present.

Other information:
- Relay/fuse box cargo compartment/Rear electronic module (REM), replacing Integrated Relay/Fusebox Cargo Compartment/Rear Electronic Module (REM), Replacing





Continue - Replacing the component

-------------------------------------------------

Replacing the component




Replace relay 2/140.

Other information:
- Relay/fuse box cargo compartment/Rear electronic module (REM), replacing Integrated Relay/Fusebox Cargo Compartment/Rear Electronic Module (REM), Replacing


Continue - Verification

-------------------------------------------------

Verification




Verification

Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on
Activate the gas tank valve relay.
There should be a clicking sound from the relay.





Is the function OK?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - Fault Found

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - FAULT-TRACING FAILED

No - Attempt New Test

------------------------

FAULT-TRACING FAILED - FAULT-TRACING FAILED

Attempt New Test - Replacing the component

-------------------------------------------------