Signal Too Low. Intermittent Fault

Signal too low. Intermittent fault

Checking wiring and connectors




- Ignition off.
Check the wiring and connectors between rear control module terminal #B26 (#E6) and the battery. Check for an intermittent open-circuit. Check for loose connections. Check for contact resistance and oxidation. Check for damage carefully.
Check the wiring between rear control module terminal #B21 (#E1) and the ground terminal. Check for an open-circuit. Check for damage carefully.
Remedy as necessary.

Other information:
- To access the rear control module connector, see Relay/fuse box cargo compartment/Rear electronic module (REM), replacing Integrated Relay/Fusebox Cargo Compartment/Rear Electronic Module (REM), Replacing
- To connect the breakout box, see Connecting the breakout box Connecting Breakout Box, Rear Electronic Module (REM)
- Checking wiring and terminals Checking Wiring And Terminals.






Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

FAULT FOUND - Fault Found

Attempt New Test - Checking wiring and connectors

-------------------------------------------------