Signal Too High. Intermittent Fault

Signal too high. Intermittent fault

Checking the wiring and component

Hint: The hands-free loudspeaker is connected to the carphone module via a connector under the driver's seat.




- Ignition off.
Check the cable between the carphone module connector A4 (terminal #4) and hands-free loudspeaker connector B10. Check the cable between carphone module connector A5 (terminal #5) and hands-free loudspeaker connector B9. Check these cables for a short-circuit to supply voltage according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Try replacing the hands-free loudspeaker if no fault is found in the wiring.
Remedy as necessary.

Other information:
- To access and replace the hands-free unit, see Handsfree equipment, replacing
- To access or replace the carphone module, see Phone module (PHM), replacing Service and Repair
- To connect the breakout box, see Connecting the breakout box. Carphone module Connecting the Breakout Box
- For information about signals and connectors, see Signal description. Phone module (PHM) Signal Description, Phone Module (PHM).














Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

Attempt New Test - Checking the wiring and component

FAULT FOUND - Fault Found

DONE - DONE

-------------------------------------------------