Signal Too High - Permanent Fault

Signal too high. Permanent fault

Checking components and wiring
Check the resistance of the evaporative emission system (EVAP) valve.
Check the signal cable between control module terminal #A9 (#A9) and evaporative emission system (EVAP) valve terminal 2. Check for a short-circuit to supply voltage.

Hint: Use a test lamp with at least a 3 W bulb to determine whether the cable is short-circuited to supply voltage.

Remedy as necessary.

Other information:
- To connect the breakout box / access the control module, see Connecting the breakout box, B5244T5, B5254T2 Connecting the Breakout Box
- For the location of components on 5 cylinder engines, see Location of components Locations
- For the location of components on 6 cylinder normally aspirated engines, see Location of components Locations
- For the location of components on 6 cylinder turbocharged engines, see Location of components Locations
- For resistance values, see Component specifications Specifications
- For information about signals on 5 cylinder engines, see Signal specification Signal Specification, ECM
- For information about signals on 6 cylinder engines, see Signal specification Signal Specification, ECM
- Checking wiring and terminals Checking Wiring And Terminals.














Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off.
- Reconnect connectors, reinstall components
- Ignition on.
- Activate canister purge (CP) valve.
A "click" should be heard when the canister purge (CP) valve is activated.









Is the canister purge (CP) valve working?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFICATION FAILED - Fault-tracing information

VERIFIED - Fault Found

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - FAULT-TRACING FAILED

No - Attempt New Test

------------------------

FAULT-TRACING FAILED - FAULT-TRACING FAILED

Attempt New Test - Checking components and wiring

-------------------------------------------------