Signal Too High - Intermittent Fault

Signal too high. Intermittent fault

Checking wiring and connectors
Check the boost pressure sensor connector. Check for contact resistance and oxidation. Check for loose connections.
Check the signal cable between control module terminal #A23 (#A23) and boost pressure sensor terminal 3. Check for an intermittent open-circuit. Check for an intermittent short-circuit to supply voltage.
Check the ground lead between control module terminal #A60 (#A60) and boost pressure sensor terminal 2. Check for an intermittent open-circuit.

Other information
- To connect the breakout box / access the control module, see Connecting the breakout box, B5244T5, B5254T2 Connecting the Breakout Box
- To access or replace the boost pressure sensor, see Temperature and pressure sensor, replacing Service and Repair
- For information about signals on 5 cylinder engines, see Signal specification Signal Specification, ECM
- For information about signals on 6 cylinder engines, see Signal specification Signal Specification, ECM
- Checking wiring and terminals Checking Wiring And Terminals.














Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

Attempt New Test - Checking wiring and connectors

FAULT FOUND - DONE

-------------------------------------------------