Signal Too High

Signal too high

Checking for permanent or intermittent faults




- Ignition on.
Press all window lift switches to check that windows operate.

Does window operate?

Yes - Intermittent fault

No - Replacing the component

-------------------------------------------------

Replacing the component




- Ignition off.
Control unit has registered an internal fault.

Note! A new control unit is supplied without software. The new control unit must be programmed before it will work.

Additional information:
- For information on programming and replacing the control unit, see Driver's door module / passenger door module (DDM/PDM), replacing Driver's Door Module/Passenger Door Module (DDM/PDM), Replacing.
After replacement of control unit it is necessary to set up the window position.






Continue - Fault Found

-------------------------------------------------

Intermittent fault




Fault-tracing information

Fault-tracing information
Fault-tracing indicates that the control module had previously identified an intermittent fault, but that the fault is no longer present.


Continue - DONE

------------------------

DONE - Trouble-shooting information

-------------------------------------------------

Trouble-shooting information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

Attempt New Test - Checking for permanent or intermittent faults

FAULT FOUND - Fault Found

-------------------------------------------------