Signal Too Low. Intermittent Fault

Signal too low. Intermittent fault

Checking the wiring




- Ignition off
- Remove windshield wiper relay 2/91 from the base.
Check the cable resistance between relay base terminal #2 and ground. Check for a short-circuit to ground.
Check the relay base switch. Check for contact resistance and oxidation.
Check the cable between relay base 2/91 terminal #2 and central electronic module (CEM) terminal #13. Check for an open-circuit.
Remedy as necessary.

Other information:
- For further information about the fuses and relays, see the Wiring Diagram
- Checking wiring and terminals Checking Wiring And Terminals










Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

Attempt New Test - Checking the wiring

FAULT FOUND - DONE

-------------------------------------------------