Signal Too High. Permanent Fault

Signal too high. Permanent fault

Checking and replacing the component
Replace the relay, 2/91.
Activate the relay for windshield wipers on.
If the function is OK, the cause of the fault was a defective relay (short-circuit in the relay).

Other information:
- For further information about the fuses and relays, see the Wiring Diagram.





Was a fault detected?

Yes - Verification

No - Checking the fusebox

-------------------------------------------------

Checking the fusebox
Remove windshield wiper relay 2/91 from the fusebox base.
Check the relay coil driver circuit for a short-circuit to supply voltage. Take a voltmeter reading between terminal #2 and ground in the relay base.
The voltage between terminal #2 and ground should be approximately 0 volt.

Other information:
- For further information about the fuses and relays, see the Wiring Diagram
- Checking wiring and terminals Checking Wiring And Terminals.









Was the function OK?

Yes - Verification

No - Checking the cable

-------------------------------------------------

Checking the cable
Check the cable between windshield wiper relay base terminal #2 and central electronic module (CEM) terminal #A13. Check for a short-circuit to supply voltage.
Remedy as necessary.
Replace the fusebox if no fault is found.

Other information:
- For further information about the fuses and relays, see the Wiring Diagram
- Checking wiring and terminals Checking Wiring And Terminals.










Continue - Verification

-------------------------------------------------

Verification




Verification

Verification

Hint: After the repair it is necessary to check that the fault has been rectified.








- Ignition off.
- Connect connectors, install components etc.
- Ignition on.
Activate the relay, windscreen wiper on.

Does it work?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - Fault Found

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - FAULT-TRACING FAILED

No - Attempt New Test

------------------------

FAULT-TRACING FAILED - No Fault Found

Attempt New Test - Checking and replacing the component

-------------------------------------------------