Signal Too Low. Intermittent Fault.

Signal too low. Intermittent fault.

Checking the indicator shunt
Check that the direction indicator shunt is fitted correctly.
At the same time check the connections, in particular the relay connection according to the table below, for an intermittent short circuit to voltage supply as described in Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults , contact resistance and oxidation as described in Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults and a loose contact as described in Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.






Additional information:
- To replace the shunt for the direction indicator, see Central electronic module (CEM), replacing Central Electronic Module (CEM), Replacing.






Continue - DONE

-------------------------------------------------