Signal Too High. Intermittent Fault

Signal too high. Intermittent fault

Checking the wiring
Remove relay 2/116.
Check the relay coil driver circuit for an intermittent short-circuit to supply voltage: Take a voltmeter reading between terminal #2 and ground in the relay base for relay (2/116).
For further information about a short-circuit to supply voltage, see Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.

Hint: The voltage between terminal #2 and ground should be approximately 0 volt.

Other information
- Central electronic module (CEM), replacing Central Electronic Module (CEM), Replacing










Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

Attempt New Test - Checking the wiring

FAULT FOUND - DONE

-------------------------------------------------