Signal Too Low. Intermittent Fault

Signal too low. Intermittent fault

Checking the signal cable








- Ignition off.
- Disconnect the connector from the central electronic module (CEM).

Hint: The signal line goes from the Central electronic module (CEM) to ground via glass breakage circuit left, glass breakage circuit right and glass breakage circuit tailgate.

Check the signal cable. Check for a short-circuit to ground.
Begin by measuring at the grounding point and then go backward along the circuit to find the defect.
Remedy as necessary.

Other information
- Connecting the breakout box Connecting the Breakout Box, Central Electronic Module (CEM)
- Signal specification Pinout Values and Diagnostic Parameters
- Central electronic module (CEM), replacing Central Electronic Module (CEM), Replacing
- For further information, see the wiring diagram.
- Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults










Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

Attempt New Test - Checking the signal cable

FAULT FOUND - Fault Found

-------------------------------------------------