Signal Too Low. Intermittent Fault

Signal too low. Intermittent fault

Checking the relay




- Ignition off.
Check that relay 2/29 is installed correctly. At the same time check the relay connections, in particular 2/29 #2, for a short circuit to ground as described in Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults. Also check the relay circuit for any open circuits, as described in Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.

Additional information:
- To replace relay, see Central electronic module (CEM), replacing Central Electronic Module (CEM), Replacing.
- To connect the test box, see Connecting the breakout box Connecting the Breakout Box, Central Electronic Module (CEM).














Continue - Trouble-shooting information

-------------------------------------------------

Trouble-shooting information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

Attempt New Test - Checking the relay

FAULT FOUND - DONE

-------------------------------------------------