Signal Too High. Intermittent Fault

Signal too high. Intermittent fault

Checking the relay




- Ignition off.
Check that relay 2/29 is installed correctly. At the same time check the relay connections, in particular 2/29#2, for a short circuit to voltage supply as described in Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.

Additional information:
- To replace relay, see Central electronic module (CEM), replacing Central Electronic Module (CEM), Replacing.
- To connect the test box, see Connecting the breakout box Connecting the Breakout Box, Central Electronic Module (CEM).














Continue - Trouble-shooting information

-------------------------------------------------

Trouble-shooting information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

Attempt New Test - Checking the relay

FAULT FOUND - DONE

-------------------------------------------------