Faulty Signal. Intermittent Fault

Faulty signal. Intermittent fault

Checking for contact resistance and oxidation




- Ignition off.
Disconnect the connectors from the left-hand seat heating module (SHM). Check all connectors. Check for contact resistance and oxidation.
Remedy as necessary.

Other information
- Checking wiring and terminals Checking Wiring And Terminals





Was a fault detected?

Yes - Fault-tracing information

No - Replacing the component

-------------------------------------------------

Replacing the component
If there is an internal fault in the heater pad, it must be replaced.
Replacing the left seat heater pad: Heater pad backrest and cushion, replacing Service and Repair


Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

Attempt New Test - Checking for contact resistance and oxidation

FAULT FOUND - DONE

-------------------------------------------------