Signal Too High. Intermittent Fault

Signal too high. Intermittent fault

Intermittent fault




- Ignition off.
Check the signal wire between central electronic module (CEM) 1D and automatic gearbox electronic lever module 3 for a short circuit to voltage supply as described in Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults
Do the necessary corrective action.

Additional information:
- For central electronic module (CEM) connector, see Central electronic module (CEM), replacing Central Electronic Module (CEM), Replacing.
- To connect the test box, see Connecting the breakout box Connecting the Breakout Box, Central Electronic Module (CEM).
- For information on signals, see Signal specification Pinout Values and Diagnostic Parameters.










Continue - Trouble-shooting information

-------------------------------------------------

Trouble-shooting information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

Attempt New Test - Intermittent fault

FAULT FOUND - DONE

DONE - DONE

-------------------------------------------------