Signal Too Low. Intermittent Fault

Signal too low. Intermittent fault

Intermittent fault




- Ignition off.
Check the cable between fuse 11/C33 terminal #2 and fuel pump (FP) relay 2/23 terminal #3. Check for a short-circuit to ground. Check for an open-circuit. Check for contact resistance and oxidation.
Remedy as necessary.

Other information:
- To access and replace the relay, see Central electronic module (CEM), replacing Central Electronic Module (CEM), Replacing
- For further information about the fuses and relays, see the Wiring Diagram
- For information about signals, see Signal specification Pinout Values and Diagnostic Parameters
- Checking wiring and terminals Checking Wiring And Terminals.














Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

Attempt New Test - Intermittent fault

FAULT FOUND - DONE

DONE - DONE

-------------------------------------------------