Parameter Fault. Permanent Fault

Parameter fault. Permanent fault

Replacing the component
If there is an internal fault in the speed-dependent power steering, it should be replaced.
Replace speed-dependent power steering (stepper motor).

Additional information
- To access/replace stepper motor, see


Continue - Verification

-------------------------------------------------

Verification




Verification

Verification

Hint: After the repair it is necessary to check that the fault has been rectified.








- Ignition off.
- Connect the connectors, install the components, etc.
- Ignition on.

Note! The engine cannot be started.

Check that diagnostic trouble code status changes from Permanent to Intermittent.





Is the status of the diagnostic trouble code Intermittent?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - Fault Found

VERIFICATION FAILED - Trouble-shooting information

-------------------------------------------------

Trouble-shooting information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - FAULT-TRACING FAILED

No - Attempt New Test

------------------------

FAULT-TRACING FAILED - No Fault Found

Attempt New Test - Replacing the component

-------------------------------------------------