Signal Too High. Intermittent Fault

Signal too high. Intermittent fault

Checking the relay
Check that relay 2/101 is correctly installed.
Also check the relay terminals for contact resistance and oxidation according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults and loose connections according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.

Other information
- For the relay box in the passenger compartment, see Central electronic module (CEM), replacing Central Electronic Module (CEM), Replacing.





Was a fault detected?

Yes - Fault Found

No - Replacing component

-------------------------------------------------

Replacing component
Replace the relay according to Central electronic module (CEM), replacing Central Electronic Module (CEM), Replacing.


Continue - Checking the relay

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

Attempt New Test - Checking the relay

FAULT FOUND - Fault Found

-------------------------------------------------