Signal Too Low. Permanent Fault

Signal too low. Permanent fault

Checking the wiring and component
Check the cable between the antenna amplifier #C1 and head unit/audio control module #A9 for a short-circuit to supply voltage according to Checking wiring and terminals. Permanent fault Checking Wiring and Terminals. Permanent Fault.
Remedy as necessary.
If no fault is found, replace the antenna amplifier.

Other information
- Radio/telephone, changing Removal and Replacement
- Radio equipment, replacing Radio Equipment, Replacing
- Connecting the breakout box, Audio control module Connecting the Breakout Box
- Signal specification, audio control module Signal Specification





Select "Continue" when the fault has been remedied.

Continue - Verification

-------------------------------------------------

Verification




Verification

Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off.
- Reinstall connectors, components etc.
- Ignition on.
Check that radio reception functions.

Does radio reception function?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - Fault Found

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - FAULT-TRACING FAILED

No - Attempt New Test

------------------------

FAULT-TRACING FAILED - FAULT-TRACING FAILED

Attempt New Test - Checking the wiring and component

-------------------------------------------------