Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information

Condition





Note! The diagnostic trouble code (DTC) applies only to ABS systems equipped with dynamic stability and traction control (DSTC).

Brake pressure sensors 1 and 2 indicate the brake system pressure to the ABS control module. Diagnostic trouble code (DTC) ABS-00A6 is stored if the control module registers that the signal from any of the pressure sensors is outside its permitted range.

Substitute value
- The anti-spin function is blocked.
- The stability function is blocked.

Possible source
- Open-circuit in the wiring.
- The wiring is short-circuited to ground or supply voltage.
- Incorrectly installed sensor.
- Defective pressure sensor.
- Defective control module.

Fault symptom[s]
- Anti-spin does not function.
- No stability function.
- Anti-spin warning lamp lit.