Signal Faulty. Intermittent Fault

Signal faulty. Intermittent fault

Checking the wiring and sensor
Check the wiring between pressure sensor 2 connection:
- #1 and control unit #26 (#A26)
- #2 and control unit #10 (#A10)
- #3 and control unit #41 (#A41)
for an intermittent open circuit as described in Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults , an intermittent short circuit to ground as described in Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults , and an intermittent short circuit to voltage supply as described in Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Do the necessary corrective action.

Additional information:
- To connect the test box, see Connecting the ABS/DSTC breakout box Pinout Values and Diagnostic Parameters.
- For checking/replacement of the pressure sensor, see Pressure sensor, master cylinder, replacing Service and Repair.
- For information on signals, see Signal specification, ABS / DSTC (dynamic stability and traction control) control module Signal Specification.










Continue - Trouble-shooting information

-------------------------------------------------

Trouble-shooting information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

FAULT FOUND - DONE

Attempt New Test - Checking the wiring and sensor

-------------------------------------------------