Signal Faulty. Intermittent Fault

Signal faulty. Intermittent fault

Checking the wiring and sensor
Check the control unit and side acceleration sensor 1 for contact resistance and oxidation, as described in Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Check the wiring between side acceleration sensor 1:
- #1 and control unit #40 (#A40)
- #2 and control unit #9 (#A9)
- #3 and control unit #25 (#A25)
for an intermittent open circuit as described in Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults , an intermittent short circuit to ground as described in Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults , and an intermittent short circuit to voltage supply as described in Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Do the necessary corrective action.

Additional information:
- To connect the test box, see Connecting the ABS/DSTC breakout box Pinout Values and Diagnostic Parameters.
- For replacement of the side acceleration sensor 1, see Replacing the yaw rate sensor (1) and the lateral acceleration sensor in the center console (DSTC) Service and Repair.














Continue - Trouble-shooting information

-------------------------------------------------

Trouble-shooting information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

FAULT FOUND - DONE

Attempt New Test - Checking the wiring and sensor

-------------------------------------------------