Faulty Signal. Intermittent Fault

Faulty signal. Intermittent fault

Checking wiring and sensors
Check the control module and yaw rate sensor terminal. Check for contact resistance and oxidation. Check the wiring between yaw rate sensor 1 connector:
- terminal #1 and control module terminal #42 (terminal #A42)
- terminal #2 and control module terminal #11 (terminal #A11)
- terminal #3 and control module terminal #27 (#A27).
Check for an intermittent open-circuit. Check for an intermittent short-circuit to ground. Check for an intermittent short-circuit to supply voltage.
Remedy as necessary.

Other information:
- To connect the breakout box, see Connecting the ABS/DSTC breakout box Pinout Values and Diagnostic Parameters
- To replace the yaw rate sensor, see Replacing the yaw rate sensor (1) and the lateral acceleration sensor in the center console (DSTC) Service and Repair
- Checking wiring and terminals Checking Wiring And Terminals














Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

FAULT FOUND - DONE

Attempt New Test - Checking wiring and sensors

-------------------------------------------------