Communication with Control Unit

Communication with control unit

Checking the wires
Check that the communication wires between the control units are not in close proximity to sources of interference such as electric motors, ignition wires, mobile telephone leads, etc.

Additional information:
- For information on wires and connections, see the relevant wiring diagram.






Continue - Trouble-shooting information
DONE

-------------------------------------------------

Trouble-shooting information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

FAULT FOUND - DONE

Attempt New Test - Checking the wires

-------------------------------------------------