Electronic Throttle Control Module: Service and Repair

Replacing The Electronic Throttle Module (ETM)







- Remove the intake manifold between the front cover plate and the air cleaner (ACL) housing.
- Disconnect the battery negative lead.







- Disconnect the hose between the charge air cooler (CAC) and the throttle body (TB) at the end of the throttle body (TB). Move to one side.
- Remove the tie strap at the connector.







- Disconnect the throttle body (TB) connector.
- Remove the throttle body (TB).
- Clean the mating surfaces thoroughly.

Installing the throttle body (electronic throttle module (ETM))

Install:
- a new throttle body (TB) with a new gasket. Tighten to 17 Nm

Connect the throttle body (TB) connector

- the tie strap at the connector
- the pipe between the throttle body (TB) and the charge air cooler (CAC)
- the intake manifold between the front cover plate and the air cleaner (ACL) housing
- the battery negative lead.

Ordering software
Order software.

Programming the control module
Program the new control module.

Finishing
- Check that no diagnostic trouble codes have been stored during the repair.
- Test drive the car. Check the function of the engine.