Pipe, Receiver/Drier, Replacing

Pipe, Receiver Drier, Replacing

Removal

NOTE: For cars with chassis numbers up to -86697, see vcc-126896

Receiver drier hoses







- Remove the condenser.







- Detach the pipe coupling from the receiver/dryer.
- Detach the pipe from the bracket. Remove the pipe.

Installation

Receiver drier hoses

NOTE: Use new O-rings lubricated with compressor oil.

- Position the pipe on the mounting in the bracket. Position the pipe coupling on the receiver/dryer.
- Position the screw and tighten the pipe coupling on the condenser.
Tighten to 10 Nm.
- Install the condenser.