Connecting the Breakout Box

Connecting The Breakout Box

Special tools: 9511428, 9511499, 9511507, 9813194

Connecting the breakout box
- Ignition off
- Remove the door panel
- Disconnect the module connectors.

NOTE: Disconnect the 12-pin connector before the 30-pin connector.

Connect the adapter to the control module connector. Connect breakout box 9511428. Connect wiring 9511499 to the adapter.

Adapter wiring 9511507 is for the 12-pin connector.
Adapter wiring 9813194 is for the 30-pin connector.

Disconnect the breakout box in reverse order.

Other information
- To remove the door panel, see Door Panel.
- For further information about signals and other values, see Signal specification. Pinout Values and Diagnostic Parameters