Checking Lamps and Needles

Checking lamps and needles

Activating lamps




- Ignition on.
Check whether the relevant lamp lights when the ignition is switched on.
Activate the system test procedures and check whether the relevant needle or lamp operates correctly. All needles should move from minimum to maximum and back again, and lamps should flash (except for the MIL). All segments in the display screen flash.
Remedy as necessary.

Other information:
- To replace the lamps, see Replacing bulb Removal and Replacement.
- To replace the gauge, see Replacing tachometer, temperature gauge, fuel gauge and speedometer Replacing Tachometer, Temperature Gauge, Fuel Gauge and Speedometer.





Continue - FAULT FOUND

-------------------------------------------------