Power Seat - Right

Calibration, entry position

Calibrating entry position, power seat - right

Note! If it is not possible to use VCT2000 for calibration, use Volvo Scan Tool (ST) as a stand-alone tool.




- Ignition off
- Disconnect the Volvo Scan Tool (ST) from the VIDA station
- Connect the Volvo Scan Tool (ST) to the data link connector (DLC). See Connecting the Volvo System Tester Connecting the Volvo System Tester
- Ignition on.
Calibrate the limit positions using the Volvo Scan Tool (ST) as a stand-alone tool. See Fault-tracing and programming using the Volvo Scan Tool (ST) Fault-Tracing and Programming Using the Volvo Scan Tool (ST).

Note! The entry position cannot be programmed using Volvo Scan Tool (ST) on control modules with P/N 8651558. The service is not available on the Volvo Scan Tool (ST) for these control modules. Calibrate manually instead. See Manually programming entry position Manually Programming Entry Position.






Continue - DONE

-------------------------------------------------