Checking The RTI Control Module

Checking the RTI control module

Fault-tracing information
Before continuing with fault-tracing, the following must be checked:
- All tests for the relevant symptom must have been carried out
- No component, connector or wiring faults etc. should have been detected.

Have all tests been carried out and no faults detected?

Yes - Replacing the component

No - All tests for the relevant symptom must have been carried out before continuing

-------------------------------------------------

Replacing the component
Try a new control module.

Other information:
- To replace and program the control module, see Replacing the control module, new system Replacing the Control Module, New System.

Continue - Verification

-------------------------------------------------





Verification

Hint: After carrying out the repair, check that the fault has been remedied as follows:








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Deploy the display using the remote control.
Check that the colors on the display screen are correct.
Switch off the ignition. Check that the display retracts.

Does the display function?

Yes - Fault has been remedied

No - Fault-tracing information

-------------------------------------------------





Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

-------------------------------------------------