Signal Missing. Intermittent Fault

Signal missing. Intermittent fault

Checking the component, wiring and connector
Check camshaft reset valve connector for intermittent contact resistance, oxidation according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults and intermittent loose connections according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Check the signal cable between engine control module (ECM) #A13 and camshaft reset valve #5 for an intermittent open-circuit according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Check power supply cable #5 and camshaft reset valve #1 for an intermittent open-circuit according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Remedy as necessary.

Other information
- To connect the breakout box, see Connecting the breakout box, B5234T9, B5244T7 Connecting The Breakout Box.
- With the ignition on and camshaft reset valve connector disconnected the voltage on connector #1 should be approximately Ubat and connector #2 be a pulse modulated signal with top voltage at approximately Ubat and with a frequency of approximately 250 Hz.
- For information about signals, see Signal specification Signal Specifications.














Continue - Fault-tracing information
DONE

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

Attempt New Test - Checking the component, wiring and connector

FAULT FOUND - DONE

-------------------------------------------------