Checking Cables

Checking Cables






Check ECC control module connector for contact resistance and oxidation according to Checking wiring and terminals - Permanent faults Checking Wiring and Terminals

Check signal cable between ECC control module #B3 and generator (GEN) terminal D+ for an open-circuit according to Checking wiring and terminals - Permanent faults Checking Wiring and Terminals

NOTE: An open-circuit on the signal cable between ECC control module #B3 and connector 24/13 can be caused by the signal cable short-circuiting to ground or supply. Always check the signal cable for this fault according to Checking wiring and terminals - Permanent faults and Checking wiring and terminals - Permanent faults Checking Wiring and Terminals

Remedy as necessary

Other information.

- To connect the breakout box Connection of Breakout Box ECC

After performing this procedure, Refer To Verification. Verification