7. Checking the Resistance In the Circuits For Solenoid S1 and S2

Checking The Resistance In The Circuits For Solenoid S1 And S2







- Ignition off
- Disconnect the control module. See Replacing the transmission control module (TCM).
- Connect the breakout box. See Connecting breakout box, Transmission control module (TCM).

Connect an ohmmeter between breakout box:

#A50 (#A50) and #A53 (#A53), solenoid S1

#B8 (#A68) and #A53 (#A53), solenoid S2

The ohmmeter should read 12-18 Ohms.

OK: Refer to Test Driving. 8. Test Driving
NOT OK: Refer to Checking For Contact Resistance and Oxidation. 9. Checking For Contact Resistance and Oxidation