Torque Bracket

Note! As the illustrations in the information are used for different model years and/or models, certain variations may occur. However, the essential information in the illustrations is always correct.

Removing the torque bracket, turbocharged engines
Remove
- Applies to turbocharged engines.





- the charge air pipe over the engine.
- the upper camshaft belt cover.
- the cover over the ignition coils.
- the screw for the torque rod.
- the torque bracket.

Removing the torque bracket, naturally aspirated engines
Remove
- Applies to naturally aspirated engines.





- the upper camshaft belt cover.
- the cover over the ignition coils.
- the screw for the torque rod.
- the torque bracket.

Installing the torque bracket
Install





- the torque bracket (A). Tighten to 50 Nm (37 ft. lbs.)
- the screws for the torque rod (B). Tighten to 35 Nm (26 ft. lbs.) +90°
- the cover over the ignition coils.
- the upper camshaft belt cover.
- any charge air pipe over the engine.

Wipe clean and check.