Hydraulic Control Assembly - Antilock Brakes: Testing and Inspection

Repair/replacement of control module connector
Repair/replacement of connector.
It is important that the leads are connected correctly after repair/replacement of the connection Check therefore the leads connections before the control module is connected
Carry out as follows
^ Ignition off
^ Connect adapter 951 1354 to the control module connector (to the cabling)
^ Connect the test box 981 3190 to the adapter
^ Control module disconnected
^ Follow the measurements given in the table Table of control module connector terminals.

Zg;3�;3�;3:

�?<3:

ȃ<3:

Table of control module connector terminals