Door Lock - Installation of Protective Cover
Section8
Group
83
No.
0032
Year
00
Month
01
Door lock, installation of protective cover
Background
A protective cover for the door locks has been introduced into production from the following chassis number.
The protective covers are separate replacement parts and are supplied as a kit containing four covers. The covers can be installed to help prevent moisture from entering the lock unit. The covers are included when ordering spare part door locks.
This Service Bulletin describes how to install the covers.
Affected vehicles
Model Factory Chassis No.
S70 2 643861-
V70 2 681913-
Material
Description Quantity Part No.
Protective cover kit (covers x 4) 1 274172
Screws 8 9187281 (not included in the kit)
Door lock, installation of protective cover
Installation of the protective cover for the door lock
Removal
1
Removing door panels
Remove the door panels.
See VADIS S70/V70 1998-2000 / Information Manager / Function Group 8 / Repairing / Removing, replacing, and installing / 83 Doors and Lids / Doors / Front and Rear doors / Door panel step 6 or the method in Service Manual: Section 8 (82-86,88) Interior trim, exterior S70/V70 1997-.
2
Removing the panel for the door lock
Remove the panel (1).
Remove the cable from the door panel.
Note!
Only the front door is illustrated.
3
Removing the lock button
Detach and remove the lock button (1) from the lever.
Note!
Only the front door is illustrated.
4
Disconnecting the guide rail (rear door)
Remove the lower screw (1) for the guide rail.
Do not move the guide rail more than 30 mm sideways from the lower mounting point when removing the lock.
5
Disconnecting the lock unit (front and rear doors)
Remove screws (B), Torx 30.
Note!
Only the front door is illustrated.
Installation
6
Positioning the protective cover
The protective covers have stamped markings that indicate the left and right hand sides.
Slide the lock out of the door.
Insert the cover at an angle over the lock (1).
Position the channel (2) (on the outside of the cover) over the corresponding projection on the lock. The cover will then be positioned correctly on the lock.
7
Installing the protective cover
Install the protective cover (1) over the lock.
8
Installing the lock unit
Slide the lock unit back into place, and fasten it with new screws. Tighten to 7.4 ft-lb (10 Nm)
9
Installing the removed components, function test
Reinstall all removed components in reverse order.
Check all door lock functions, including remote locking and unlocking.
Check all other electrical functions related to removing and installing the door panel.
WARRANTY STATEMENT: Claims may be submitted under the New Car Warranty when there is a documented customer complaint, using claim type 01.
Operation No. Labor description Time allowance
86945-2 Installing the protective cover for the door lock according
to SB 83-0032 Front door 1.9 hr
Rear door 1.9 hr