6. Checking For Contact Resistance and Oxidation

Checking For Contact Resistance And Oxidation
Check the control module and transmission connectors. Check for contact resistance and oxidation.

Check the cable between transmission connector (transmission side) #23 and lock-up solenoid SL. Check for a short-circuit to supply voltage. Check for a short-circuit to ground. Check for an open-circuit.

Other Information
- To access the transmission connector, see Inspecting/cable harness to solenoids
- To check/replace lock-up solenoid SL, see Inspecting/replacing solenoids
- Checking wiring and terminals

Select Continue when the fault has been remedied.

Continue: Refer to Verification. 8. Verification