Checking Wiring and Sensors

Checking Wiring And Sensors







- Ignition off.

Check the power supply cable between transmission control module (TCM) terminal 57A and vehicle speed sensor (VSS) connector terminal 1 for an open-circuit according to Checking wiring and terminals. Permanent faults.

Check the signal cable between transmission control module (TCM) terminal 39A and vehicle speed sensor (VSS) connector terminal 2 for an open-circuit according to Checking wiring and terminals. Permanent faults.

HINT: With the control module connected, the ignition on and a voltmeter connected between vehicle speed sensor (VSS) connector terminals 1 and 2 (control module side), the voltage should be approximately 1 V under Ubat.

Remedy as necessary.

Other Information:
- To connect the breakout box, see Connecting breakout box, Transmission control module (TCM).
- To disconnect the transmission control module (TCM), see Replacing the transmission control module (TCM).
- To check/replace the vehicle speed sensor (VSS), see Replacing vehicle speed sensor (VSS).
- For information about signals, see Signal specification, Transmission control module (TCM).

Continue: Refer to Verification. Verification