Checking Wiring and Components

Checking Wiring And Components







- Ignition off.

Check cable between control module #A51 and transmission connector (control module side) #23 for a short-circuit to ground according to Checking wiring and terminals. Permanent faults.

Check cable between transmission connector (transmission side) #23 and lock-up solenoid SL for a short-circuit to ground according to Checking wiring and terminals. Permanent faults.

HINT: With the ignition off and control module disconnected the resistance between control module #A51 and ground (breakout box #53) should be 11-15 Ohms.

Remedy as necessary.

Other Information:
- To connect the breakout box, see Connecting breakout box, Transmission control module (TCM).
- To disconnect transmission connector, see Inspecting/cable harness to solenoids.
- To check/replace lock-up solenoid SL, see Inspecting/replacing solenoids.
- For information about signals, see Signal specification, Transmission control module (TCM).

Select Continue when the fault has been remedied.

Continue: Refer to Resetting the Adaptation. Resetting the Adaptation