Checking Lock-Up Solenoid SL

Checking Lock-Up Solenoid SL







- Ignition off
- Remedy control module and transmission connectors for contact resistance and oxidation according to Checking wiring and terminals. Permanent faults.
- Reinstall components, reconnect connectors etc.
- Ignition on.
- Gear selector in position P.
- Activate lock-up solenoid SL.

The value should change between OFF and ON.

If the value changes between OFF and ON the cause of the fault was contact resistance or oxidation.

Does the value change?

YES: Refer to Trouble Code Descriptions. Diagnostic Trouble Code Descriptions
NO: Refer to Checking Wiring and Components. Checking Wiring and Components