Signal Too High. Intermittent Fault

Intermittent Fault







Check wiring between control module #A22 and transmission connector #24 and between control module #A70 (#B10) and transmission connector #25 for an intermittent short-circuit to supply voltage according to Checking wiring and terminals. Intermittent faults.

Check wiring between transmission connector #24 and #25 and the line pressure solenoid connectors for an intermittent short-circuit to supply voltage according to Checking wiring and terminals. Intermittent faults.

Remedy as necessary.

Other Information:
- To connect the breakout box, see Connecting breakout box, Transmission control module (TCM).
- To disconnect transmission connector, see Inspecting/cable harness to solenoids.
- To access shift solenoid STH, see Inspecting/replacing solenoids.
- For information about signals, see Signal specification, Transmission control module (TCM).

Select Continue when the fault has been remedied.

Continue: Refer to Fault-Tracing Information - Intermittent Fault. Fault-Tracing Information - Intermittent Fault