3. Checking Wiring and Components

Checking Wiring And Components







- Ignition off.

Check cable between control module #A68 (#B8) and transmission connector (control module side) #22 for a short-circuit to supply voltage according to Checking wiring and terminals. Permanent faults.

Check cable between transmission connector (transmission side) #22 and solenoid S2 for a short-circuit to supply voltage according to Checking wiring and terminals. Permanent faults.

Remedy as necessary.

Other Information:
- To connect the breakout box, see Connecting breakout box, Transmission control module (TCM).
- To disconnect transmission connector, see Inspecting/cable harness to solenoids.
- To check/replace shift solenoid S2, see Inspecting/replacing solenoids.
- For information about signals, see Signal specification, Transmission control module (TCM).

Select Continue when the fault has been remedied.

Continue: Refer to Resetting the Adaptation. 4. Resetting the Adaptation