2. Intermittent Fault

Intermittent Fault







Check cable between control module #A68 (#B8) and solenoid S2 for an intermittent short-circuit to supply voltage according to Checking wiring and terminals. Intermittent faults.

HINT: Voltage should be approximately 12 V with the ignition on and voltmeter connected to control module #A68 (#B8) and ground.

Remedy as necessary.

Other Information:
- To connect the breakout box, see Connecting breakout box, Transmission control module (TCM).
- For other values, see Signal specification, Transmission control module (TCM).

Select Continue when the fault has been remedied.

Continue: Refer to Fault-Tracing Information - Intermittent Fault. Fault-Tracing Information - Intermittent Fault