Checking Connector and Cable, Continued

Checking Connector And Cable, Continued







- Ignition off.
- Reinstall the seat belt buckle connector.
- Check the seat belt buckle connector #2 for a short-circuit to ground according to Checking wiring and terminals - Permanent faults.
- Disconnect the control module connector.
- Ignition on.

Check cable between seat belt buckle connector #2 and control module connector #12 for an open-circuit and a short-circuit to ground.

Checking Wiring and Terminals - Permanent Faults

Remedy as necessary.


Other information


CAUTION
It is grounded at the sensor casing.

After performing this procedure Checking Component