Checking Connector

Checking Connector







- Make a note of anti-theft radio code.
- Ignition off.
- Disconnect battery negative lead.
- Disconnect control module and ignition switch connectors.

Remedy ignition switch and control module connector for contact resistance and oxidation according to Checking wiring and terminals - Permanent faults.

Check for damage etc.

Check cable between battery and ignition switch and cable between ignition switch and control module #5 for an open-circuit according to Checking wiring and terminals - Permanent faults and a short-circuit to ground according to Checking wiring and terminals - Permanent faults.
Checking Wiring and Terminals - Permanent Faults

Remedy as necessary.


After performing this procedure Checking Generator (GEN)