Checking Cables

Checking Cables







Check fuse 18.

Hint: If the fuse is blown, check the circuit after fuse 18 for a short-circuit to ground according to Checking wiring and terminals - Permanent faults, then replace fuse.

Check the cable between ignition switch #S and fuse 18, and the cable between fuse 18 and control module #B10 for an open-circuit according to Checking wiring and terminals - Permanent faults.

Checking Wiring and Terminals - Permanent Faults

Remedy as necessary.

Other information:
- For further information about signals and other values, see Control Module Pinout Values.
- To connect the breakout box, Reading and Clearing Diagnostic Trouble Codes

After performing this procedure Verification