Verification

Verification







Hint: After carrying out the repair, check that the fault has been remedied.

- Ignition off.
- Remove the key from the ignition switch.
- Reinstall connectors, components etc.
- Shut all doors, the hood and the trunk lid.
- Sit in the driver's seat and activate the alarm with the remote control.
- Insert the key in the ignition switch and switch on the ignition within 25 seconds. This is so that the alarm will be in set mode.

Read off diagnostic trouble codes (DTCs).

The diagnostic trouble code (DTC) should now have switched to intermittent if the fault is no longer present.