Checking Cables

Checking Cables







- Ignition off.

Check fuse 6.

Hint: If the fuse is blown, check the circuit after fuse 6 for an open-circuit according to Checking wiring and terminals - Permanent faults.

Check the cable between control module #B15 and siren #5 for a short-circuit to ground according to Checking wiring and terminals - Permanent faults and for an open-circuit according to Checking wiring and terminals - Permanent faults. Check the cable between fuse 6 and siren #4 for an open-circuit according to Checking wiring and terminals - Permanent faults.

Checking Wiring and Terminals - Permanent Faults

Other information:
- The voltage between siren #4 and ground should be battery voltage.
- For further information about signals and other values, see Control Module Pinout Values.
- To connect the breakout box, Reading and Clearing Diagnostic Trouble Codes

Remedy as necessary.

After performing this procedure Erasing Diagnostic Trouble Codes (DTCs)