Signal Too High - Intermittent Fault

ECM-9300 CLUTCH PEDAL POSITION SENSOR, FAULTY SIGNAL
SIGNAL TOO HIGH - INTERMITTENT FAULT

Checking wiring and connectors



Check clutch pedal sensor connector for loose connections according to [1][2]Checking Wiring and Terminals. Intermittent Faults

Check signal cable between engine control module (ECM) #B15 and clutch pedal sensor #2 for an intermittent open-circuit according to [1][2]Checking Wiring and Terminals. Intermittent Faults and an intermittent short-circuit to supply voltage according to [1][2]Checking Wiring and Terminals. Intermittent Faults

Check signal cable between engine control module (ECM) #B4 and clutch pedal sensor #4 for an intermittent open-circuit according to [1][2]Checking Wiring and Terminals. Intermittent Faults and an intermittent short-circuit to supply voltage according to [1][2]Checking Wiring and Terminals. Intermittent Faults

Other information
- To connect the breakout box, Connecting the Breakout Box (ECM)
- For information about signals, see Diagnostic Parameters and Pinout Values. Signal Description, ME7, B5XX4T


Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.